Adding Solvent to the Volumetric Flask
previous page

hide narration
show narration

 

 

URL (link address) for this media:
http://www.dvaction.org/dvaction/movies/progressive/euc-NU-0003.mov

Carefully add solvent to bring the solution up to the calibration mark. When the level of the solution is just below the mark, stop adding solvent. Let the flask sit a short time to allow the solvent to drain from the walls.
Use a pipet, or other small dispenser, to fill the flask the remainder of the way. The bottom of the meniscus should lie even with the calibration line.